Re: NANFA-- Aquarium Stands

EELReprah_at_aol.com
Fri, 12 Dec 2003 09:30:00 EST

In a message dated 12/12/03 8:03:47 AM, Prizma_at_aol.com writes:

<< i built a 7' tall stand from one sheet of 3/4" plywood. it houses / stacks
4)
10 gallon tanks which leaves about 6" in between each one. ( this is enough
for water changes and most maintenance. ) the tanks are supported on each
side
by 2" angle aluminum. when the tanks are minimally empty they can be slid out
for whatever service is needed. >>

So this is a 4 tier, 4 tank module? I resume that multiples of this are used
side by side. I would like to see a picture.

Lee Harper
Media, PA
/-----------------------------------------------------------------------------
/"Unless stated otherwise, comments made on this list do not necessarily
/ reflect the beliefs or goals of the North American Native Fishes
/ Association"
/ This is the discussion list of the North American Native Fishes Association
/ nanfa_at_aquaria.net. To subscribe, unsubscribe, or get help, send the word
/ subscribe, unsubscribe, or help in the body (not subject) of an email to
/ nanfa-request_at_aquaria.net. For a digest version, send the command to
/ nanfa-digest-request_at_aquaria.net instead.
/ For more information about NANFA, visit our web page, http://www.nanfa.org